How I Became An Expert on Reviews

How to Use Plasma Cutters Safely and Effectively Plasma cutting is a precious tool for getting quick, precise cuts in steel, aluminum, or stainless. This is attainable with the use of plasma cutters that merge a high-pressure air or gas flow with an electric arc. The heat can achieve a temperature of up to 40,000 degrees Fahrenheit. The following are some things to keep in mind while you’re using a plasma cutter: Safety is Priority While plasma cutting is not as intense as welding, you have to proceed as though it is. Make it a point to wear flame-retardant clothes and hair covering. Put on glasses #5 eye protection and work in a safe location. Be familiar with your surroundings. Remember that the heat and light can be great, and you should ensure your safety.
Equipment – Getting Started & Next Steps
Consumables
What Research About Equipment Can Teach You
Each time you notice that your cuts are losing their sharpness, you might need to change some or all of the components of the cutting head. Mostly, this will consist of a heat shield, contact tip, insulators, nozzle, and offset tool. It’s essential that you check the availability of such consumables when you buy your plasma cutter. Pick a new model with a simple process for ordering parts. The Importance of Moisture Plasma cutters need clean, dry air in order to function properly. Moisture is the main culprit of parts losing efficiency and turning bad. There are a few things you can do to stall the effects of moisture, and restrict it to a bare minimum. Provide 25 to 30 feet of line between the moisture trap and from the air compressor. The moisture trap will work more efficiently if the air has an opportunity to cool first. Buy an air drier that makes use of silica gel to bring out moisture from the air. Get two, in fact – they are cheap. These can be set up at the compressor and at the water trap to extend the life of your consumables. The air driers themselves are easier and less expensive to replace than the plasma cutter parts. Cutting Speed You have to cut at the correct speed. If you’re new to plasma cutting, it could take you a few attempts to get it dialed in well. One of the surest indicators is the direction of the sparks as you cut. When cutting too fast, the sparks move towards you. Relax and slow it down. The sparks and dross have to head to the floor. The Angle Often, you would hold the plasma cutter at 90-degree angle to what you are cutting. Reaching the end of a cut, pull the angle up a bit to make for a beautifully smooth end of cut. If you see some dross on the underside of your cut, a small file can take care of that.